Errors > File Not Found Error - 2002-04-10

~ 0 min
2010-01-05 20:14

If when you try and save a file in 3D you receive a message that says, "Can not save the file ______ because file not found" attempt the following work around (if you have the Norton Utilities):

- Leave the model alone, start Norton Unerease.
- Read the volume, get back your model-file (last modify-date), although it contains nearly 0k.
- Put it back in place where it should be.
- Switch to Strata and save.

A message appears, which will tell you that this file is maybe modified etc. Save anyway.

Average rating 0 (0 Votes)

You cannot comment on this entry